$15 Off On Order Over $100 Promo Code SAVE15
HOT SEARCH

Replacement Filter For:

Kenmore 25370343412

  • Filter Features
  • Filter Life: 6-Months

  • Filter Capacity: 200 Gallon

  • Taste

  • Odor

  • Chlorine

  • Reduces 34 Contaminants Including Pharmaceuticals

  • Largest Selection:
  • Bring Kenmore refrigerator water filter to replace the inefficient Unknown in your 25370343412 from Clatterans. Kenmore 25370343412 Unknown is recommended to be changed every three or six months to do its best filtration result but depending on the water source and how many times you use. The filter replacement is tested and certified to IAPMO and NSF/ANSI standard 42 for the reduction of most contaminants and substances including chlorine, lead, mercury and thallium. Install the Unknown is much easier and without tools needed. Savor healthy life from Clatterans.   

How to replace your filter

1.Turn Off the ice maker and remove the filter by pushing on the end/face of the filter.
 
2.Slide the old water filter cartridge straight out of the housing and discard it.
 
3.Unpackage the new filter cartridge. Using the alignment guide, slide it gently into the filter housing until it stops against the snap-in connector at the back of the housing.
 
4.Turn the filter clockwise until it locks into the housing.
NOTE: If the filter is not correctly locked into the housing, the water dispenser will not operate.
Water will not flow from the dispenser.
 
5.Push firmly until the cartridge snaps into place
(you should hear a click as the cartridge engages the snap-in connector).
 
6.Run water from the dispenser for 5 minutes at.5 gpm (about 2½ gallons) to clear the system and prevent sputtering.
NOTE: Initial rate may be slower than expected. Full rate should be restored within 24-36 hours
 
7.Reset the “replace filter" light, if needed, by holding the reset button for three seconds.
 

Customer Review

RATING

0

OUT OF 5

TOTAL REVIEWS

0

SATISFACTION

0%

Top customer reviews

    FAQ

    How often should you replace your water filter?
     
    - On average, most filters last 6 months or 300 gallons depending on your water quality and usage.
     
    How do I turn off my filter light to reset?
     
    - If the filter light will not reset after following specific instructions from your owner manual, contact your refrigerator manufacturer.
     
    Do the gaskets (o-rings) on the filters need to be lubricated?
     
    - Most water filters come with pre-lubricated O-rings
     
    - If you are having trouble installing the filter, we have found that a small amount of vegetable oil applied to the O-ring will ease installation and removal of the filter.
     
    I just installed my filter; do I need to run water through it before I drink the water? If so, how much?
     
    - You should run 3 gallons of water through your filter in order to flush it and make sure that it is thoroughly wet. Do not run the 3 gallons continuously, instead run the water for a few minutes and stop in between. Get a gallon water container, and pour and refill 3 times!
    Live Customer Support
     
    Our hours of operation are Monday thru Friday from 8:00am to 6:00pm Eastern Time and our after hours sales team is available 24 hours a day, 7 days a week. Whether it’s placing an order or answering questions that may help in your purchasing decisions, our specialists are ready to assist you. You can also contact us via email.