$15 Off On Order Over $100 Promo Code SAVE15
HOT SEARCH

Replacement Filter For:

Whirlpool GSS30C6EYY02

  • Filter Features
  • Filter Life: 6 Months

  • Filter Capacity: 400 Gallons

  • Filter Type: Generic

  •  

  • Largest Selection:
  • Bring whirlpool refrigerator water filter to replace the inefficient Filter 1,9081,9930 in your gss30c6eyy02 from Clatterans. whirlpool gss30c6eyy02 Filter 1,9081,9930 is recommended to be changed every three or six months to do its best filtration result but depending on the water source and how many times you use. The filter replacement is tested and certified to IAPMO and NSF/ANSI standard 42 for the reduction of most contaminants and substances including chlorine, lead, mercury and thallium. Install the Filter 1,9081,9930 is much easier and without tools needed. Savor healthy life from Clatterans.   

Compatibility

Whirlpool Refrigerator Models

How to replace your filter

1 Locate the filter below the refrigerator. Slowly turn the cartridge a 1/4 of a turn counter-clockwise and remove. Remove the knob from the former filter.

2 Remove all packaging, and the protective cap from the new filter.

3 Slide the knob from the former filter onto the new filter. Insert the new filter into the refrigerator and turn clockwise until fully seated.

4 Run water from the dispenser for 5 minutes (approximately 3 gallons) to clear the system and prevent air from entering the system
NOTE: The initial flow rate may be slower than expected. Full flow rate should be restored within 24-36 hour

5 Press the light switch (the one that the refrigerator door presses every time you close the door) 5 times within 10 seconds, or if the refrigerator has a filter button, press and hold that button for 5-10 seconds

6 Locate the included Water Filter Replacement Calendar and follow the instructions on the labe




 

Customer Review

RATING

4.8

OUT OF 5

TOTAL REVIEWS

544

SATISFACTION

96%

Top customer reviews

  • A product that works great

    By KATHLEEN HARVEY on 2024-04-16 00:00:00

    A very good product. Just what I needed for my fridge..

  • Great product

    By Terry Howe on 2024-04-10 00:00:00

    easy install lasts about 6 months

  • Great Filter

    By Robert Engstrom on 2024-04-03 00:00:00

    Needed for our fridge - it works and works well.

  • A reliable and efficient filter!

    By Michael on 2024-02-26 00:00:00

    It worked exactly as I expected, and the price was fair. I have no complaints whatsoever.

  • There's no longer any unpleasant taste in my refrige water.

    By James on 2024-01-09 00:00:00

    The FILTER was delivered exactly as I ordered. It was exactly what was shown on the website!

  • I must say, this filter is outstanding.

    By Pat on 2024-01-09 00:00:00

    It arrived quickly and functions flawlessly. It's a fantastic product that I'm thoroughly satisfied with!

    FAQ

    How often should you replace your water filter?

    - On average, most filters last 6 months or 300 gallons depending on your water quality and usage.

    How do I turn off my filter light to reset? 

    - If the filter light will not reset after following specific instructions from your owner manual, contact your refrigerator manufacturer.

    Do the gaskets on the filters need to be lubricated?

    - Most water filters come with pre-lubricated O-rings

    - If you are having trouble installing the filter, we have found that a small amount of vegetable oil applied to the O-ring will ease installation and removal of the filter.

    I just installed my filter; do I need to run water through it before I drink the water? If so, how much?

    - You should run 3 gallons of water through your filter in order to flush it and make sure that it is thoroughly wet. Do not run the 3 gallons continuously, instead run the water for a few minutes and stop in between. Get a gallon water container, and pour and refill 3 times!