$15 Off On Order Over $100 Promo Code SAVE15
HOT SEARCH

Replacement Filter For:

Maytag EDR2RXD1

  • Filter Features
  • NSF Certified 42 & 531

  • Filter Life: 6 Months

  • Filter Capacity: 200 Gallons

  • Change your Maytag filter with Clatterans water filter replacement every six months or longer to get the clearer and cleaner water from your Maytag refrigerator. Approved by IAPMO and NSF/ANSI 42, Maytag EDR2RXD1 will leave you the peaceful mind that the filtered water from EDR2RXD1 Maytag refrigerator is reliable to drink for the household. The superb carbon delivers drinking water and ice without nasty impurities and harmful elements like dirt and lead, mercury which will pose health issues if we drink for a long time. Change the filter is much easier as everything is prepared well.

How to replace your filter

1.Locate the accessory packet in the refrigerator and remove the water filter.
 
2.Take the water filter out of its packaging and remove the cover from the O-rings. Be sure the O-rings are still in place after the cover is removed.
NOTE: There may be some water in the filter. Some spilling may occur. Use a towel to wipe up any spills.
 
3.Align the arrow on the water filter label with the cutout notch in the filter housing and insert the filter into the housing.
4.Turn the filter clockwise until it locks into the housing.
NOTE: If the filter is not correctly locked into the housing, the water dispenser will not operate. Water will not flow from the dispenser.
 
5.While the compartment door is still open, lift the filter up into the compartment. Then, close the filter compartment door completely.
 
6.Run water from the dispenser for 5 minutes at .5 gpm (about 2½ gallons) to clear the system and prevent sputtering.
NOTE: Initial rate may be slower than expected. Full rate should be restored within 24-36 hours
 
7.Reset the “replace filter” light, if needed, by holding the reset button for three seconds.

Customer Review

RATING

4.9

OUT OF 5

TOTAL REVIEWS

441

SATISFACTION

98%

Top customer reviews

  • worth

    By Saundra on 2024-04-16 00:00:00

    I have to buy it for my fridge. It keeps the water and ice delicious.

  • All good.

    By Scott Burch on 2024-04-15 00:00:00

    Its perfect.

  • Just buy one already

    By Marcia Nelson on 2024-04-09 00:00:00

    Works great, popped right in. Instructions were clear. Would buy again

  • Great product

    By Ann Hewitt on 2024-04-06 00:00:00

    The filter is easy to install.

  • Easy to change

    By Annette on 2024-04-05 00:00:00

    Easy to change and keep your water systems clean

  • Great product

    By Johnathon Bruton on 2024-04-02 00:00:00

    No issue

    FAQ

    Common Water Filter Questions

    How often should you replace your water filter?

    - On average, most filters last 6 months or 300 gallons depending on your water quality and usage.

    How do I turn off my filter light to reset?

    - If the filter light will not reset after following specific instructions from your owner manual, contact your refrigerator manufacturer.

    Do the gaskets (o-rings) on the filters need to be lubricated?

    - Most water filters come with pre-lubricated O-rings

    - If you are having trouble installing the filter, we have found that a small amount of vegetable oil applied to the O-ring will ease installation and removal of the filter.

    I just installed my filter; do I need to run water through it before I drink the water? If so, how much?

    - You should run 3 gallons of water through your filter in order to flush it and make sure that it is thoroughly wet. Do not run the 3 gallons continuously, instead run the water for a few minutes and stop in between. Get a gallon water container, and pour and refill 3 times!